Trolling motor mount
Trolling motor mount
Mounted a trolling motor to my Malibu Kayak using the tracking system, so the arm is removable. Here is what it looks like. Hope to water test it soon. Sorry about the video being blurry in spots... Dang cell phone has a mind of its own!
https://youtu.be/ucwiWcFwPS4
https://youtu.be/ucwiWcFwPS4
- TigerLandSportsman
- Posts: 297
- Joined: Tue Jul 05, 2016 8:48 am
Re: Trolling motor mount
40 hp is a lot for a kayak
Re: Trolling motor mount
pretty sure it is 40lbs, not 40hp ![Smile :)](./images/smilies/icon_smile.gif)
I used 40lbs motor on malibu stealth 14 -- it is a perfect match (because it is a beast to paddle without motor)
![Smile :)](./images/smilies/icon_smile.gif)
I used 40lbs motor on malibu stealth 14 -- it is a perfect match (because it is a beast to paddle without motor)
Re: Trolling motor mount
Yep... 40lbs thrust - my bad ![Smile :)](./images/smilies/icon_smile.gif)
![Smile :)](./images/smilies/icon_smile.gif)
- kickingback
- TKF 5000 Club
- Posts: 5178
- Joined: Thu Feb 18, 2016 3:24 pm
- Location: Houston, Texas
Re: Trolling motor mount
I use a 24 lb Watersnake TM for my Hobie PA. It's just small enough to fit into the mirage drive.
Did you take into effect the heavy weight of the TM and the battery you plan to use? Since the TM is on the right side and sticking out that far you will need to "lean" to your left or sit to your left to balance the kayak, not to mention the weight of the battery and where you will put it in the kayak. If you move the TM closer to the kayak it will make the center of gravity more toward the yak instead of away from it. You used metal also and that adds to the weight as well.
What size battery and type you plan to use?
I use a 100 AH (amp hour) AGM (sealed no acid to replace) battery and it weighs 70 lbs and I can go 12-15 hours of non stop moving with it. It weighs my kayak down quite a bit but it is rated for 350 lbs and I only weigh 175. You will need to put the battery on the opposite side of your kayak to balance better and it wont tip when you get out.
For a 40 lb TM you will only get about 6-10 hours of use from a 100 AH battery. You could go smaller with a 35 AhH battery and it weighs half that of the 100 AH. You will only get about 3-6 hours but not full throttle the whole time.
Good work!
Did you take into effect the heavy weight of the TM and the battery you plan to use? Since the TM is on the right side and sticking out that far you will need to "lean" to your left or sit to your left to balance the kayak, not to mention the weight of the battery and where you will put it in the kayak. If you move the TM closer to the kayak it will make the center of gravity more toward the yak instead of away from it. You used metal also and that adds to the weight as well.
What size battery and type you plan to use?
I use a 100 AH (amp hour) AGM (sealed no acid to replace) battery and it weighs 70 lbs and I can go 12-15 hours of non stop moving with it. It weighs my kayak down quite a bit but it is rated for 350 lbs and I only weigh 175. You will need to put the battery on the opposite side of your kayak to balance better and it wont tip when you get out.
For a 40 lb TM you will only get about 6-10 hours of use from a 100 AH battery. You could go smaller with a 35 AhH battery and it weighs half that of the 100 AH. You will only get about 3-6 hours but not full throttle the whole time.
Good work!
Re: Trolling motor mount
The Kayak I mounted it to is pretty wide and stable. There was no noticeable tilt when I mounted it, but hope to test it in water soon and can add a counterbalance if needed soon. I have 2 battery options - 100Ah and a 35Ah - the 35 is not very big or heavy, the 100 is. I plan to use the 35 most of the time, as I will only need it to get to and from my spots so if I can get a couple hours out of it, I should be good. I am not concerned about the weight as I have transported kids, even adults in the kayak without issue. I'll post an update once I test it.
- OrangeQuest
- TKF 1000 Club
- Posts: 1707
- Joined: Wed Aug 18, 2010 10:39 am
- Location: West of Southwest Houston
Re: Trolling motor mount
You know that you need to register it with TPWD if you use the TM in public waters right?
Re: Trolling motor mount
Yep... In the process of doing that.
Re: Trolling motor mount
Update...
Tested out the new Trolling motor in a small lake, and it was a success. Mount held up like a champ. There was a slight lean to the motor side, but not enough to worry about. Achieved 3.5 mph - that usually what I'm at when paddling aggressively. Video is below...
https://youtu.be/Uo8FRdXYXgs
Tested out the new Trolling motor in a small lake, and it was a success. Mount held up like a champ. There was a slight lean to the motor side, but not enough to worry about. Achieved 3.5 mph - that usually what I'm at when paddling aggressively. Video is below...
https://youtu.be/Uo8FRdXYXgs
- kickingback
- TKF 5000 Club
- Posts: 5178
- Joined: Thu Feb 18, 2016 3:24 pm
- Location: Houston, Texas
Re: Trolling motor mount
Good work! testing is always key!
-
- Posts: 11
- Joined: Fri Feb 15, 2019 10:51 am
Re: Trolling motor mount
I am in the process of doing something like this. What does it take to get it registered wth tpwd??