Texas Tepee
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Texas Tepee
Travel Trailer
I will do a short pictorial of the build and if anyone has question just holler
It all starts here
Laid out a 78 1/2 by 8 ft floor
laid out the walls ,added 2 ft to the side walls ,the trailer is 10 ft in length
Stood the sidewalls and attached them to the floor.
to be continued
I will do a short pictorial of the build and if anyone has question just holler
It all starts here
Laid out a 78 1/2 by 8 ft floor
laid out the walls ,added 2 ft to the side walls ,the trailer is 10 ft in length
Stood the sidewalls and attached them to the floor.
to be continued
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: Texas Tepee
Backwall and roof stringers installed
door cut in
back wall installed and braced for ac then the interer with a saturation coat on the inside walls
windows and door framed on inside walls
bracing for nose installed
trailer skinned completely
The outside was covered with saturation coat of resin seams taped and glassed
Later
door cut in
back wall installed and braced for ac then the interer with a saturation coat on the inside walls
windows and door framed on inside walls
bracing for nose installed
trailer skinned completely
The outside was covered with saturation coat of resin seams taped and glassed
Later
-
- TKF 2000 club
- Posts: 2426
- Joined: Sat Apr 12, 2008 8:42 pm
- Location: Guadalupe County
- Contact:
Re: Texas Tepee
Great! Don't forget where you left us...this is something I've wanted to see for several months!
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: Texas Tepee
Construction
skin 4mm laun 3/.4 lumbers bracing (1 inch )
3/4 foam insulation
inside walls 4 mm laun
floor 1/2 ply saturated inside seams glassed on outside and h skin is saturated
installing foam in walls
inside completely skinned bed fram and storge being built
A note here it is set up for a single bed when I go solo and a queen when the better half goes.
outside with screw holes filled and seams sanded
windows and door installed
startrd building cabinets in front of trailer
Storage on each side and the center is cut out for a stove.
Later
skin 4mm laun 3/.4 lumbers bracing (1 inch )
3/4 foam insulation
inside walls 4 mm laun
floor 1/2 ply saturated inside seams glassed on outside and h skin is saturated
installing foam in walls
inside completely skinned bed fram and storge being built
A note here it is set up for a single bed when I go solo and a queen when the better half goes.
outside with screw holes filled and seams sanded
windows and door installed
startrd building cabinets in front of trailer
Storage on each side and the center is cut out for a stove.
Later
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: Texas Tepee
Sanded and first coat of paint
I went and picked up some steel and built the frame
Painted axle installed
box mounted on the frame and bolted down
Later
Ron
I went and picked up some steel and built the frame
Painted axle installed
box mounted on the frame and bolted down
Later
Ron
Re: Texas Tepee
One heck of a Craftsman right Ya'll.
Re: Texas Tepee
This guy has some skills. Keep the pics coming!!!!!!
- gerald
- TKF 4000 Club
- Posts: 4174
- Joined: Thu Jun 12, 2003 10:48 am
- Location: Gatesville, tx www.theoldmansboats.com
Re: Texas Tepee
Ron, that is great! Man...this Boat Builder Forum is getting better and better. I think we're on to something here fellas...
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: Texas Tepee
Gerald
I know this was off subject ,but some of the guys were interested.
I ran 2 by 4 roof joist so if I want to I can mount two Kayak rack on top of the trailer.
I cut them so I had a 3/4 inch rise in the middle to shed water. There is an power vent ,12 volt, mounted on the roof.
When finished it will have a twelve volt light and fan system and also a 110 volt light ac system.
Ron
I know this was off subject ,but some of the guys were interested.
I ran 2 by 4 roof joist so if I want to I can mount two Kayak rack on top of the trailer.
I cut them so I had a 3/4 inch rise in the middle to shed water. There is an power vent ,12 volt, mounted on the roof.
When finished it will have a twelve volt light and fan system and also a 110 volt light ac system.
Ron
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: Texas Tepee
Friday morning before the bash I still ha d a ways to go.
install a jack
weld on the trailer coupler chains and wire the trailer
and of course I had a short in the trailer plug on the jeep I had to run down.
Mounted back lights and license plate oh yea had to go regester it so I could get a license plate
Later Ron
install a jack
weld on the trailer coupler chains and wire the trailer
and of course I had a short in the trailer plug on the jeep I had to run down.
Mounted back lights and license plate oh yea had to go regester it so I could get a license plate
Later Ron
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: Texas Tepee
I was hooked up and left Sat morning early ,first time to pull the trailer and have two yaks on top,the little four banger handled it with ease, and I averaged 17 miles to the gallon so I was happy with that. I was nearly 8 ft tall ,I wasn't sure how it would handle it.
Trailer pulled straight and true no bobbles.
You know the story of the storm at the bash,well I just dropped the trailer in the sight and went looking for the wood boats. I finally found them enjoyed seeing the boats and folks. by the I was wet cold and misrable,I am just opisite of Kim I like hot weather and hate being cold.
I went back to the camper plugged in the lights put a pot of coffe on ,in about two minutes I was opening a vent and window nice and cozy. I drank the coffe laid down and crashed for a couple hours ,dang bed sleeps good.
It has a real mattress
I can sit up on the bed and still have plenty head room.
Picture from the bed foreward
This is not the stove I will use but it worked for this weekend.
My first trip with my rig was a success, no leaks ,open the door and go in,no tent cot sleeping bag to worry about, warm dry and comfortable, and It took all of five minutes to break camp
I am no where close to complete on this project but it is campable and I am very happy with the TEXAS TEPEE
Later
Ron
Trailer pulled straight and true no bobbles.
You know the story of the storm at the bash,well I just dropped the trailer in the sight and went looking for the wood boats. I finally found them enjoyed seeing the boats and folks. by the I was wet cold and misrable,I am just opisite of Kim I like hot weather and hate being cold.
I went back to the camper plugged in the lights put a pot of coffe on ,in about two minutes I was opening a vent and window nice and cozy. I drank the coffe laid down and crashed for a couple hours ,dang bed sleeps good.
It has a real mattress
I can sit up on the bed and still have plenty head room.
Picture from the bed foreward
This is not the stove I will use but it worked for this weekend.
My first trip with my rig was a success, no leaks ,open the door and go in,no tent cot sleeping bag to worry about, warm dry and comfortable, and It took all of five minutes to break camp
I am no where close to complete on this project but it is campable and I am very happy with the TEXAS TEPEE
Later
Ron
Re: Texas Tepee
Way cool!
- Night Wing
- TKF 10,000 Club
- Posts: 33440
- Joined: Wed Sep 24, 2003 9:30 pm
- Location: Magnolia, TX
Re: Texas Tepee
Simply incredible. Great job! BTW, the bed in the trailer was my favorite.
Re: Texas Tepee
So how much would you charge for one (assuming you would have time to build one to sell)? Not kidding You can pm me...
Kim
Kim
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: Texas Tepee
Kim
Let me think about that for a while . I will get back to you.
Ron
Let me think about that for a while . I will get back to you.
Ron
Re: Texas Tepee
That's awesome, Ron. Great job! I know this is a Boat Builder Forum, and I enjoy watching you guys build boats, but I'd like to see more things like this. Sort of a All-Things-DIY Forum. Again, cool stuff, Ron.
-
- TKF 2000 club
- Posts: 2426
- Joined: Sat Apr 12, 2008 8:42 pm
- Location: Guadalupe County
- Contact:
Re: Texas Tepee
Excellent! Hard to beat ingenuity+talent+hard work!
- ~BUCKSHOT~
- TKF 1000 Club
- Posts: 1582
- Joined: Sat Jun 16, 2007 11:31 am
- Location: sour lake, tx. (TEAM TKF)
- Contact:
Re: Texas Tepee
Great job Ron, you have some serious skills!!!
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: Texas Tepee
Fellos I appreciate the thumbs up, I just like to tinker.
Ron
Ron
-
- TKF 1000 Club
- Posts: 1786
- Joined: Mon Feb 04, 2008 8:35 am
- Location: San Antonio
Re: Texas Tepee
Damn cool
We did not get to see it Saturday. I am distracted by by fish chasing. Guess we were in a hurry to beat the front to the Guad.
We did not get to see it Saturday. I am distracted by by fish chasing. Guess we were in a hurry to beat the front to the Guad.
Re: Texas Tepee
Excellent job! Whole lot of possibilities there!
I think that I found this link via this site?
http://www.mikenchell.com/forums/index. ... 107cf9ab02" onclick="window.open(this.href);return false;
Love the DIY'er frame of mind!
I think that I found this link via this site?
http://www.mikenchell.com/forums/index. ... 107cf9ab02" onclick="window.open(this.href);return false;
Love the DIY'er frame of mind!
- Light Keeper's Kid
- TKF 1000 Club
- Posts: 1528
- Joined: Tue Nov 11, 2008 6:37 pm
- Location: Stuck in the Middle, Wadefish 15' -Heritage 9.5 Angler (OlllllO)
Re: Texas Tepee
WOW Cool link it's got me thinking
Mike
Mike
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: Texas Tepee
Here is a link to that website for a more detailed build of the TEPEE.
Lot of info on that site.
Ron
http://www.mikenchell.com/forums/viewtopic.php?t=26560" onclick="window.open(this.href);return false;
Lot of info on that site.
Ron
http://www.mikenchell.com/forums/viewtopic.php?t=26560" onclick="window.open(this.href);return false;
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: Texas Tepee
Another thing I forgot to mention ,my rods,tackle box , yak paddles lifejackets were all stored under the bed in the storage,
I think I am going to get spoiled to this rig.
Ron
I think I am going to get spoiled to this rig.
Ron
Re: Texas Tepee
You certainly have a lot of time on your hands. That was a great job. It looked like an entertainment center for a flat screen tv instead of for a camp stove. I think we need to start a project builder of the year award, and you certainely would get my vote. Kudos to you.