TexasKayakFisherman.com est. 2000

Kayak fishing the Lone Star State...

OK, so I've done some googling and I have seen and read of some different ways to get rid of the bubbles that are created when mixing the the resin and hardener. I don't own a heat gun so that's out of the question. Some of the ways I've seen and read about that I can do at very cheap if not no cost is to mist a little bit of Acetone on it after waiting 5 minutes for it to self level. Another way is to get a straw and blow hot air on the bubbles but I am afraid I'll pass out doing this. Another way I read about is taking your brush and dip it in mineral spirits, ring it out so it's not dripping and then brush over the bubbles with it. Is there any other ways that you guys do to get rid of these bubbles that is cost/ quality effective?? Have any of you used the acetone way? Thanks in advance.

are you talking about epoxy?
if so
2 tricks ,pass a torch "propane can " type on top of the area
repeat several times like 6 inches away from surface.

num 2 "do you smoke??"
get your cigarrete and blow the smoke to the surface
works like a charm!
Old town predator mk

I recently got a old town predator mk and the rudd[…]

Colorado River Access

RiverSchool Camp is still a pay for access place, […]

Guadalupe River

Nice Winnie. What campground did you stay ?

What did you tie today?

Nice! Do you use belly or back hair? Like the pat[…]