TexasKayakFisherman.com est. 2000

Kayak fishing the Lone Star State...


User avatar
By Ron Mc
#2282106
my buddy hangs his boats in netting on hoists - he modified the support on a pulley system
Image

I keep mine on sawhorses under the scuppers with kayak-hull-shaped foam blocks between the boat and sawhorse - very handy to work on rigging this way
Image
I lift each end to remove the blocks one at a time, back up my truck with bed extender, and slide the boat right on
ImageFrom blocks are also handy for stacking boats in your truck bed
It's also easy to single-hand your long boat from a bed extender - walk it out as far as you can and set that end down, lift and swing the other end.
Last edited by Ron Mc on Mon Feb 04, 2019 9:55 pm, edited 2 times in total.
User avatar
By Kirk B.
#2282107
I have a Jackson Cuda 12 at around 80 lbs. I have it suspended on a ceiling hoist. All of the accessories and all of my fishing stuff is piled inside for storage.


Kirk B.
By Taildragger321
#2283612
Ron Mc wrote:my buddy hangs his boats in netting on hoists - he modified the support on a pulley system
Image

I keep mine on sawhorses under the scuppers with kayak-hull-shaped foam blocks between the boat and sawhorse - very handy to work on rigging this way
Image
I lift each end to remove the blocks one at a time, back up my truck with bed extender, and slide the boat right on
ImageFrom blocks are also handy for stacking boats in your truck bed
It's also easy to single-hand your long boat from a bed extender - walk it out as far as you can and set that end down, lift and swing the other end.


Is the netting a truck bed net?

Where did you get your foam for the sawhorses?

Thanks.
Landbased shark fishing rigs

Check out the BTB section of the site. You can use[…]

East Flats - April 14, 2019

Great work guys, nice thread. Just like the good o[…]

Hobie passport 1299

stringer cleat

shopping around for rigging supplies, found a pre-[…]