TexasKayakFisherman.com est. 2000

Kayak fishing the Lone Star State...


Please Visit our Sponsor Hook1 Kayak Fishing Gear
#2241659
The only exposed parts to the salt water are your drive shaft and metal parts on the control unit. If your in salt for the day bring a jug of fresh water to rinse drive shaft inside prop housing immediately after you pull load up. The seal inside keeps the water from entering the motor housing so theres no worries there. I would rinse and turn on the troller (1st speed is fine) then rinse again to make sure you get all the saltwater out of the seal area on the shaft. This will prolong the life of your unit.
What did you tie today?

https://uploads.tapatalk-cdn.com/201[…]

Somerville - Yegua creek

Looked like a nice day to be out catching like you[…]

How should I mount my transducer?

Anyone have any thoughts on mounting a skimmer tra[…]

Solo Skiff Feedback?

Good choice on motor and trailer. I wish I had roo[…]